A factory assembled, pressure tested, multi spring, balanced cartridge seal suitable for pumps, agitators & mixers. This compact, low profile seal fits all ANSI pumps without modification.
NUTECH 1 MECHANICAL SEAL
Features and Benefits
EASY TO INSTALL - No measuring is required to install the NUTECH I cartridge seal.
NO SHAFT OR SLEEVE WEAR - There are no dynamic "O" rings on the shaft to cause fretting to your equipment and the seal is designed so that all wear parts are disposable.
ALIGNMENT - Stationary seats are resiliently mounted on an "O" ring and allowed to float for maximum face squareness.
IMPELLER ADJUSTMENT PUMPS - The NUTECH I can be installed on pumps requiring an impeller adjustment after the seal is installed. Adjustments can be made without removing the seal or dismantling the pump.
NO MODIFICATION TO EQUIPMENT - The NUTECH I low profile seal fits all ANSI pumps without modification and is superior in dimensional specifications to any other single cartridge seal commercially available.
API - Given pump information the NUTECH I can be manufactured to meet the American Petroleum Institute specifications for many petrochemical services.
3 WAY CLIPS - A clip design that not only centers seal but stops axial movement in both directions.
"OFF THE SHELF" AVAILABILITY - The NUTECH I seal is available in 1.00" to 4.00". Larger shaft diameters are available on request.
PRESSURE TESTED - All NUTECH I seals are pressure tested before leaving our factory.
*Consult factory
** EPR, KALREZ, AFLAS, T.V.
Special material and design features available upon request.
Aflas is a registered trademark of Asahi Flass Co. Ltd.
Hastelloy is a registered trademark of Cabot Corp.
Viton and Kalrez are registered trademarks of Dupont.